25L1005MC – MX25L1005MC

Part Number : 25L1005MC

Function : MX25L1005MC

Manufactures : Macronix International

Images :

1 page
25L1005MC image

2 page
pinout

Description :

MX25L1005 MX25L1005 DATASHEET The MX25L1005 product family is not recommended for new designs. The MX25L1005C family is the recommended replacement. Please refer to MX25L1005C datasheet for full specifications and ordering information, or contact your local sales representative for additional support. P/N: PM1238 REV. 2.0, APR. 15, 2009 1 MX25L1005 1M-BIT [x 1] CMOS SERIAL FLASH The MX25L1005 product family is not recommended for new designs. The MX25L1005C family is the recommended replacement. Please refer to MX25L1005C datasheet for full specifications and ordering information, or contact your local sales representative for additional support. FEATURES GENERAL • Serial Peripheral Interface (SPI) compatible — Mode 0 and Mode 3 • 1,048,576 x 1 bit structure • 32 Equal Sectors with 4K byte each – Any Sector can be erased individually • 2 Equal Blocks with 64K byte each – Any Block can be erased individually • Single Power Supply Operation – 2.7 to 3.6 volt for read, erase, and program operations • Latch-up protected to 100mA from -1V to Vcc +1V PERFORMANCE • High Performance – Fast access time: 85MHz serial clock (15pF + 1TTL Load) and 66MHz serial clock (30pF + 1TTL Load) – Fast program time: 1.4ms(typ.) and 5ms(max.)/page (256-byte per page) – Fast erase time: 60ms(typ.) and 120ms(max.)/sector (4K-byte per sector) ; 1s(typ.) and 2s(max.)/block (64K-byte per block) • Low Power Consumption – Low active read current: 12mA(max.) at 85MHz, 8mA(max.) at 66MHz and 4mA(max.) at 33MHz – Low active programming current: 15mA (max.) – Low active erase current: 15mA (max.) – Low standby current: 10uA (max.) – Deep power-down mode 1uA (typical) • Minimum 100,000 erase/program cycles SOFTWARE FEATURES • Input Data Format – 1-byte Command code • Block Lock protection – The BP0~BP1 status bit defines the size of the area to be software protected against Program and Erase instructions. • Auto Erase and Auto Program Algorithm – Automatically erases and verifies data at selected sector – Automatically programs and verifies data at selected page by an internal algorithm that automatically times the program pulse widths (Any page to be programed should have page in the erased state first) • Status Register Feature P/N: PM1238 REV. 2.0, APR. 15, 2009 2 • Electronic Identification – JEDEC 2-byte Device ID – RES command, 1-byte Device ID HARDWARE FEATURES • SCLK Input – Serial clock input • SI Input – Serial Data Input • SO Output – Serial Data Output • WP# pin – Hardware write protection • HOLD# pin – pause the chip without diselecting the chip • PACKAGE – 8-pin SOP (150mil) – 8-land USON (2x3x0.6mm) – All Pb-free devices are RoHS Compliant MX25L1005 GENERAL DESCRIPTION MX25L1005 is a CMOS 1,048,576 bit serial Flash memory, which is configured as 131,072 x 8 internally.The MX25L1005 feature a serial peripheral interface and software protocol allowing operation on a simple 3-wire bus […]

3 page
image

25L1005MC Datasheet



This entry was posted in Uncategorized. Bookmark the permalink.