Part Number : MC9S08FL8
Function : Microcontrollers
Manufactures : Freescale Semiconductor
MC9S08FL8 is Microcontroller.
Related Documentation: • MC9S08FL16 (Data Sheet) Contains pin assignments and diagrams, all electrical specifications, and mechanical drawing outlines. Find the most current versions of all documents at: http://www.freescale.com MC9S08FL16RM Rev. 1 3/2009 freescale.com MC9S08FL16 Features 8-Bit S08 Central Processor Unit (CPU) • Up to 20 MHz CPU at 4.5 V to 5.5 V across temperature range –40 °C to 85 °C • HC08 instruction set with added BGND instruction • Support for up to 32 interrupt/reset sources On-Chip Memory • Up to 16 KB flash read/program/erase over full operating voltage and temperature • Up to 1024-byte random-access memory (RAM) • Security circuitry to prevent unauthorized access to RAM and flash contents Power-Saving Modes • Two low power stop modes; reduced power wait mode • Allowing clocks to remain enabled to specific peripherals in stop3 mode Clock Source Options • Oscillator (XOSC) — Loop-control Pierce oscillator; crystal or ceramic resonator range of 31.25 kHz to 39.0625 kHz or 1 MHz to 16 MHz • Internal Clock Source (ICS) — Internal clock source module containing a frequency-locked-loop (FLL) controlled by internal or external reference; precision trimming of internal reference allows 0.2% resolution and 2% deviation over temperature and voltage; supports bus frequencies up to 10 MHz System Protection • Watchdog computer operating properly (COP) reset with option to run from dedicated 1 kHz internal clock source or bus clock • Low-voltage detection with reset or interrupt; selectable trip points • Illegal opcode detection with reset • Illegal address detection with reset • Flash block protection Development Support • Single-wire background debug interface • Breakpoint capability to allow single breakpoint setting during in-circuit debugging (plus two more breakpoints) • On-chip in-circuit emulator (ICE) debug module containing two comparators and nine trigger modes Peripherals • IPC — Interrupt priority controller to provide hardware based nested interrupt ADC — 12-channel, 8-bit resolution; 2.5 μs conversion time; automatic compare function; 1.7 mV/°C temperature sensor; internal bandgap reference channel; operation in stop; optional hardware trigger; fully functional from 4.5V to 5.5 V • TPM — One 4-channel and one 2-channel timer/pulse-width modulators (TPM) modules; selectable input capture, output compare, or buffered edge- or center-aligned PWM on each channel • MTIM16 — One 16-bit modulo timer with optional prescaler • SCI — One serial communications interface module with optional 13-bit break; LIN extensions Input/Output • 30 GPIOs including one input-only pin and one output-only pin Package Options • 32-pin LQFP • 32-pin SDIP MC9S08FL16 MCU Series Reference Manual Covers: MC9S08FL16 MC9S08FL8 MC9S08FL16 Rev. 1 3/2009 Revision History To provide the most up-to-date information, th […]