QCA4002 Datasheet – Intelligent Wi-Fi Platform

Part Number : QCA4002

Function : Qualcomm Unveils Low-Power Wi-Fi Platform

Package : MQFN 56 Pin Type

Manufacturers : QUALCOMM Incorporated

Image :

QCA4002 datasheet

 

Description :

QCA4002 is an intelligent Wi-Fi platform for the Internet of Things (IoT). This complete networking platform enables customers to add full-featured Wi-Fi to a wide variety of products with minimal development effort and cost.

Features

1. IEEE 802.11n 1×1 single or dual-band 2.4GHz/5GHz

2. Single or dual Rx front end for receive diversity

3. Integrated on-chip processor and memory

4. Cost optimized RBOM with integrated PA and LNA

5. Full security support: WPS, WPA, WPA2 and WEP

6. SPI and UART host interface

7. Data rates up to 10Mbps

8. Integrated IPv4/IPv6 networking stack

9. Green Tx power savings and Low power Rx listen

Block Diagram

 

Reference site :

1. Single-band 1×1 stream MQFN Wi-Fi Chipset
2. Qualcomm Unveils Low-Power Wi-Fi Platform

Other data sheets within the file : QCA4004

QCA4002 Datasheet PDF Download

 

AP6255 Datasheet – WiFi 11ac + Bluetooth 4.1 Module

Part Number : AP6255

Function : WiFi 11ac + Bluetooth 4.1 Module

Pakcage : PLCC 44 Pin

Manufactures : AMPAK Technology ( www.ampak.com.tw )

Images :

AP6255 Datasheet WiFi Module

 

General Specification
1. Model Name : AP6255
2. Product Description : Support Wi-Fi/Bluetooth functionalities
3. Dimension : L x W x H: 12 x 12 x 1.5 (typical) mm
4. WiFi Interface : SDIO v2.0/v3.0
5. BT Interface : UART / PCM
6. Operating temperature : -30°C to 85°C
7. Storage temperature : -40°C to 85°C
8. Humidity : Operating Humidity 10% to 95% Non-Condensing

1 page
AP6255 image

Pin Definition

1 GND - Ground connections
2 WL_BT_ANT I/O RF I/O port
3 GND - Ground connections
4 NC - Floating (Don’t connected to ground)
5 NC - Floating (Don’t connected to ground)
6 BT_WAKE I HOST wake-up Bluetooth device
7 BT_HOST_WAKE O Bluetooth device to wake-up HOST
8 NC - Floating (Don’t connected to ground)
9 VBAT P Main power voltage source input

42 UART_TXD O Bluetooth UART interface
43 UART_RXD I Bluetooth UART interface
44 UART_CTS_N I Bluetooth UART interface

2 page
pinout

Description :

正基科技股份有限公司 SPECIFICATION SPEC. NO.: DATE: 04. 26. 2015 PRODUCT NAME: REV: 1.1 AP6255 APPROVED CHECKED PREPARED DCC ISSUE NAME AMPAK Technology Inc. www.ampak.com.tw Doc. NO: Proprietary & Confidential Information AMPAK AP6255 WiFi 11ac + Bluetooth 4.1 Module Spec Sheet AMPAK Technology Inc. www.ampak.com.tw Doc. NO: Proprietary & Confidential Information 1 AP6255 Datasheet Revision History Date 2015/04/09 2015/04/26 Revision Content – Preliminary – Add GPIO pin definiion Revised By Version Gary 1.0 Gary 1.1 AMPAK Technology Inc. www.ampak.com.tw Doc. NO: Proprietary & Confidential Information 2 AP6255 Datasheet Contents Contents . 3 1. Introduction . 4 2. Features . [ .]

Features

1. IEEE 802.11a/b/g/n/ac dual-band radio with virtual-simultaneous dual-band operation
2. Single-stream spatial multiplexing up to 433.3 Mbps data rate.
3. Supports 20, 40, 80 MHz channels with optional SGI(256 QAM modulation)
4. Bluetooth V4.0+EDR with integrated Class 1 PA and Low Energy (BLE) support
5. Concurrent Bluetooth, and WLAN operation
6. Simultaneous BT/WLAN receive with single antenna

Reference site : http://forum.khadas.com/t/linux-wifi-ap6255-firmware/717/11

AP6255 Datasheet