25L1605A PDF – CMOS Serial Flash Memory – MX25L1605A

Part Number: 25L1605A, MX25L1605A

Function: 16M-Bit, CMOS Serial Flash Memory

Package: SOP 16, SON 8, SOP 8 Pin Type

Manufacturer: Macronix International

Preview Images:25L1605A pdf datasheet

Description

CMOS Serial Flash Memory is a type of non-volatile memory that uses Complementary Metal-Oxide-Semiconductor (CMOS) technology and a serial interface to store data. It is commonly used in a wide range of electronic devices, such as microcontrollers, embedded systems, communication devices, and consumer electronics.

The 25L1605A is a CMOS 16,777,216 bit serial Flash memory, which is configured as 2,097,152 x 8 internally. The MX25L1605A features a serial peripheral interface and software protocol allowing operation on a simple 3-wire bus. The three bus signals are a clock input (SCLK), a serial data input (SI), and a serial data output (SO). SPI access to the device is enabled by CS# input.

After program/erase command is issued, auto program/erase algorithms which program/ erase and verify the specified page or sector/block locations will be executed.

Features:

• Serial Peripheral Interface (SPI) compatible — Mode 0 and Mode 3

• 16,777,216 x 1 bit structure

• 512 Equal Sectors with 4K byte each
– Any Sector can be erased individually

• 32 Equal Blocks with 64K byte each
– Any Block can be erased individually

• Single Power Supply Operation
– 2.7 to 3.6 volt for read, erase, and program operations

• Latch-up protected to 100mA from -1V to Vcc +1V

• Low Vcc write inhibit is from 1.5V to 2.5V

Pinouts:

25L1605A pinout memory

1. CS# Chip Select

2. SI Serial Data Input

3. SO Serial Data Output

4. SCLK Clock Input

5. HOLD# Hold, to pause the device without deselecting the device

6. VCC + 3.3V Power Supply

7. GND Ground

25L1605A PDF Datasheet

TT2076 PDF – Small kVA 3 Phase Isolation Transformer

Part Number: TT2076

Function: 2000VA, Small kVA 3 Phase Isolation Transformer

Package: Module Type

Manufacturer: TEMCo

Images:TT2076 pdf transformer

Description

TT2076 is Three-Phase, 2000 VA, Small kVA 3 Phase Isolation Transformer. An isolation transformer is a type of transformer used to electrically isolate one circuit from another while allowing the transfer of electrical power between them. It achieves this isolation by physically separating the primary winding (input) from the secondary winding (output) and providing galvanic isolation, meaning there is no direct electrical connection between the two windings.

Features

1. Copper windings

2. 1.5 to 2 week build time

3. Soldily fixed terminals with standard combination slotted Robertson head screw connections facilitate wiring.

4. Built with heat-proof insulation for compact size and long life.

5. Unique bobbin-wound coils for greater efficiency, superior heat evacuation, and compact structure.

 

Optional Features

1. NEMA 4/4x

2. Encapsulation

3. Other voltages/multiple tap

4. Electrostatic shield

TT2076 datasheet

Other Information :

1. TT2076 Transistor – 800V, NPN, Sanyo

TT2076 PDF Datasheet