LM324 Datasheet PDF – Quadruple OP Amp – TI

Part Number: LM324

Function: Quadruple Operational Amplifier

Package: DIP or SMD 14 Pin Type

Manufacturer: Texas Instruments

Image:

LM324 op amps

 

Descripition :

These devices consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply over a wide range of voltages.

Operation from split supplies also is possible if the difference between the two supplies is 3 V to 32 V (3 V to 26 V for the LM2902 device), and VCC is at least 1.5 V more positive than the input common-mode voltage.

LM324 Pinout

LM324 Datasheet

LM324 pinouts

 

The low supply-current drain is independent of the magnitude of the supply voltage. Applications include transducer amplifiers, dc amplification blocks, and all the conventional operational-amplifier circuits that now can be more easily implemented in single-supply-voltage systems.

For example, the LM124 device can be operated directly from the standard 5-V supply that is used in digital systems and provides the required interface electronics, without requiring additional ±15-V supplies.

 

LM324 Features

1. Unity-Gain Bandwidth

Gain bandwidth product is found by multiplying the measured bandwidth of an amplifier by the gain at which that bandwidth was measured. These devices have a high gain bandwidth of 1.2 MHz.

2. Slew Rate

The slew rate is the rate at which an operational amplifier can change its output when there is a change on the input. These devices have a 0.5-V/μs slew rate.

3. Input Common Mode Range

The valid common mode range is from device ground to V CC – 1.5 V (V CC
– 2 V across temperature). Inputs may exceed V CC up to the maximum V CC
without device damage. At least one input must be in the valid input common mode range for output to be correct phase. If both inputs exceed valid range then output phase is undefined. If either input is less than –0.3 V then input current should be limited to 1 mA and output phase is undefined.

4. Device Functional Modes
These devices are powered on when the supply is connected. This device can be operated as a single supply operational amplifier or dual supply amplifier depending on the application.

Official Homepage : https://www.ti.com/product/LM324

 

LM324 Datasheet Downlaod 

LM324 pdf