TB2931HQ PDF – 49W BTL x 4ch, Audio Amplifier

Part Number: TB2931HQ

Function: 49W BTL x 4channel, Audio Amplifier

Package: HZIP 25 Pin Type

Manufacturer: Toshiba

Images:TB2931HQ pdf datasheet

Description

TB2931HQ is a power IC with built-in 4-channel BTL amplifier developed for car audio.

A 4-channel BTL (Bridge-Tied Load) audio amplifier is a type of audio amplifier that is capable of driving four speakers or loads independently. The term “BTL” refers to the bridge-tied load configuration, which is a specific amplifier topology used to increase the output power of the amplifier.

In a bridge-tied load configuration, two amplifier channels are combined to drive a single speaker or load. This effectively doubles the voltage swing across the load, thereby increasing the available output power. By using this configuration, the 4-channel BTL audio amplifier can provide higher power output to each speaker compared to a standard single-ended amplifier.

The output stage uses DMOS and consists of upper P-ch and lower N-ch pure complementary, realizing a maximum output power POUT = 49 W.

It also incorporates a standby switch, mute function, and various protection circuits necessary for car audio.

Standby switch function (4 pins)

Power ON/OFF control is possible by controlling pin 4 (Stand-By terminal) to High and Low. The threshold voltage of pin 4 is set to about 2 VBE (typ.) and the power supply current in standby mode is about 0.01 µA (typ.).

Block diagram:

TB2931HQ pinout amplifier

TB2931HQ PDF Datasheet

SYN460R-FS12 PDF Datasheet – 1250Hz, ASK Receiver

Part Number: SYN460R-FS12

Function: 300-450MHz ASK Receiver

Package: SOP-8 Pin type

Manufacturer: Synoxo

Images:SYN460R-FS12 pdf datasheet

 

Description

The SYN460R-FS12 is a single chip ASK/OOK (ON-OFF Keyed) RF receiver IC. This device is a true
“antenna-in to data-out” monolithic device. All RF and IF tuning are accomplished automatically
within the IC which eliminates manual tuning and reduces production costs. The result is a highly
reliable yet low cost solution.

All IF filtering and post-detection (demodulator) data filtering is provided within the SYN450R,
so no external filters are necessary. One of four demodulator filter bandwidths may be selected
externally by the user

Features

1. 300MHz to 440MHz frequency range

2. High receiver sensitivity: -106dBm (315MHz), -107dBm (433MHz)

3. Data-rate up to 10kbps (fixed-mode)

3. 3.7mA fully operational (315MHz)

4. 0.9μA in shutdown

5. 370μA in polled operation (10:1 duty-cycle)

6. Wake-up output flag to enable decoders and microprocessors

 

Applications:

1. Automotive Remote Keyless Entry (RKE)

2. Remote controls

3. Remote fan and light control

4. Garage door and gate openers

 

SYN460R-FS12 PDF Datasheet

SYN460R-FS12 pdf